SCB-PT
22
Software trigger
Click the trigger button to trigger the controller, the trigger button is
now divided into :
When the cycle works, the positive and negative pressure trigger
intervals are the values set by the cycle.
When the controller completes the positive and negative pressure state,
the completion of the software prompts the lamp to light up
and
the fault will extinguish
.
Modifying parameters
After modifying the parameters of the cycle or holding time, click the
application button on the right side of the cycle to modify the settings
and save the controller.
Modifying air pressure settings
The corresponding gear is selected, and the sliding bar adjustment on
the right side of the corresponding setting value is dragged ( numerical
synchronization is shown in the right box ). Clicking the button on the
right side can modify the air pressure setting value of the corresponding
Trigger controller for positive pressure loading state
Trigger controller for negative pressure open state
Trigger controller for pressure release state
The trigger controller works in a loop state
