PowerControl VI: Getting Started
29 May 2008 7
Schoberer Rad Messtechnik GmbH
Rudolf Schulten Str. 6
D-52428 Jülich
Tel.: +49 (2461) 69123-0
Fax:+49 (2461) 69123-17
SRM Service Center Inc.
720 West Monument Street
Colorado Springs, CO 80904
USA
Tel.: +1 (719) 266 4127
Fax: +1 (710) 266 4284
www.srm.de
To setup your PowerControl VI press the setup button
Please setup:
- your initials (up to 20 characters).
- the interval of storage (seconds)
The slope of the PowerMeter can be set up manually or automatically (if you set the slope to 0.00 Hz/Nm,
the PowerControl will pick up the preprogrammed slope of the PowerMeter).
FCC Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and may cause
harmful interference to radio communications if not installed and used in accordance with the instructions. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver
•
Connect the equipment into an outlet that is on a different circuit from GPS unit.
•
Consult the dealer or an experienced radio/TV technician for help.
This product does not contain any user-serviceable parts. Repairs should only be made by an authorized SRM
service center. Unauthorized repairs or modifications could result in permanent damage to the equipment, and void
your warranty and your authority to operate this device under Part 15 regulations.
