PowerControl VI: Getting Started
29 May 2008 2
Schoberer Rad Messtechnik GmbH
Rudolf Schulten Str. 6
D-52428 Jülich
Tel.: +49 (2461) 69123-0
Fax:+49 (2461) 69123-17
SRM Service Center Inc.
720 West Monument Street
Colorado Springs, CO 80904
USA
Tel.: +1 (719) 266 4127
Fax: +1 (710) 266 4284
www.srm.de
You need to pair the PowerControl VI with the power, speed and heartrate sensors.
If you don’t do this, no data will be received by the PowerControl VI for any of the sensors
that you want to use on your bike.
Pairing the sensors with the PowerControl VI will only be possible if they are
switched on.
•
Switch on the PowerMeter by pedaling the crank backwards a few times
(it will switch on when sensor in the PowerMeter passes the magnet
attached to the bottom bracket).
•
Switch on the Speed sensor by spinning the wheel.
•
Switch on Heart Rate sensor by putting the belt on your chest. To have a
better contact please moisten the electrodes.
•
Switch on the PowerControl by pressing the
button.
Hold
for about 3 seconds to enter Sensor Pairing mode.
Press
once quickly to select the device you want to pair and press
once quickly to tell the PC VI to start searching.
The Antenna symbol
blinking on the right of the display shows that the
searching process has started.
The search bar in the middle of the display shows the progress of the search.
If no signal is picked up, please check:
•
If the sensor is switched on
•
The position of the magnet
•
If the battery is charged
•
If it is still not working, please get in touch with the Service Center
If a Sensor is found, the PC VI will show “Found” in the
Top line, alternating with the Sensor’s Serial number.
If the pairing fails, please repeat step 1 and 2.
To pair another Sensor, press
once quickly to get back to the device
selection Menu. Continue with pairing the Heartrate sensor and Speed sensor.
Hold
for about 3 seconds to leave the device pairing menu and go back to
the main menu.
It is also possible to program the sensor identification numbers in the SRM Windows Software. This will make
the pairing unnecessary.
Sensor Pairing
