Model SR7005
i
Wall Mount In-Room Mini Scale
Operating and Service Manual
Part No. MAN7005i_200520
Page 4 of 16
S
Instruments, Inc.
,
600 Young Street, Tonawanda, NY 14150
Tel: 716-693-5977 Fax: 716-693-5854 URL:
www.srscales.com
email:
Copyright 2020
S
Instruments, Inc.
27-5/8” from
floor
Crossbar
Mounting Holes
are 16” on Center
19” from
floor
AC Power
Supply Plug
INSTALLATION (Cont’d)
STEP 3:
To mount the SR7005
i
Wall Mount In-Room Mini Platform Scale you can use either:
The wall mount bracket supplied with the scale (Figure 1) or
Use the two crossbar mounting holes on the crossbar which are located 16” apart (Figure 2).
USING THE WALL MOUNTING BRACKET
STEP (a)
: For stud walls, use a stud finder and locate any studs in the mounting area.
STEP (b):
Measure up from the floor 27-5/8” and make a mark at a stud location. This will be the location
of bottom edge of the wall mounting bracket (Figure 2). Level the wall bracket and mark all three screw
locations.
For concrete walls, measure up from the floor 27-5/8” and make a mark, Level the wall bracket and mark
all three screw locations.
STEP (c):
For wall mounting locations without a stud, use a screwdriver to drive the provided self-drilling
wall anchors into the wall. It is not recommended to use a power drill to set the wall anchors.
For concrete wall mounting, install appropriate wall anchors at all marked screw locations.
Figure 1: Wall Bracket
Figure 2: Wall Bracket Installation
WARNING
THE WALL BRACKET OR CROSSBAR
MUST BE SECURELY ANCHORED TO THE
WALL USING APPROPRIATE HARDWARE
Continued next page