1009510 Rev A
5
3. Engine Choke Control Lever:
Place in the closed position when starting a cold engine.
Position the lever halfway between open and closed when the
engine starts and to the full-open position once the engine has
warmed up.
4. Recoil Starter:
To start the engine, set the choke and the throttle and grasp
the starter grip and pull slowly until the starter engages. Then
pull the cord sharply to start the engine. Repeat if necessary
with the choke opened slightly.
Parking
Brake
Lever
Free Wheel
Lever
Slicer Depth
Lever
5. Slicer Depth Lever:
Adjust the slicer blades from transport to dethatching or
slicing. To adjust the slicer depth:
1. Press down on the operating handle to remove weight
from front wheels.
2. Squeeze the lock handle and move slicer lever to
achieve desired depth of cut between 1/4 in. above
ground to 1 in. into ground.
6. Free Wheel Lever:
BYPASS
(FREE WHEEL)
DESVÍO
(RUEDA LIBRE)
OPERATION
(DRIVE)
OPERACIÓN
(ACCIONAMIENTO)
Controls Bypass (free wheel) and Operation (drive) functions
of the trans-axle. Push in and down for Bypass. Pull out and
down for Operation.
7. Parking Brake Lever:
Pull up to release parking brake. Pull out and down to engage
parking brake.
Forward
Ground Speed
Control Lever
Reverse
Ground Speed
Control Lever
Seed Flow
Metering
Gauge
Engine
Throttle
Lever
Seed Flow
Lever
Slicer Blade
Control
Lever
8. Engine Throttle Lever:
Moving the throttle lever from the front to the rear decreases
the engine speed. To start the engine, position the throttle
halfway between slow and fast
9. Forward / Reverse Ground Speed Control
Levers:
Located on the right side of the control handle is the forward
ground speed control lever. The left lever is for reverse. These
two levers control the maximum output of the hydrostatic
trans-axle and thus the ground speed of the spreader
