1009510 Rev A
15
I
II
III
9. Remove pulley at slicer by:
I. Unscrew key set screw. Using a 7/16 in. wrench,
unscrew each of the 1/4” bolts from the bushing.
II. After removing the bolts, re-install one into each of
the three threaded holes on the bushing.
As you tighten the bolts, the bushing should
separate from the pulley.
III. Remove the bushing and pulley from the shaft.
NOTE:
The shaft has a key at the end where the
pulley is assembled which may come out when you
remove the pulley. In the event that this happens,
please take care not to lose the key. The slicer
blades will not turn without the key.
Loosen and remove
bolts on both sides
10. Remove the 1/2” hex bolts and 1/2” hex nuts that
attach bearings to engine frame (note (2) bolts on
each side of frame).
Remove
11. Remove the complete blade assembly with bearings.
