1009510 Rev A
17
I
II
III
B
A
25. Reinstall pulley on the end of the slicer that was
previously removed:
I. Using a 7/16 in. wrench, unscrew each of the
1/4” bolts from the bushing.
II. Assemble the bushing the the pulley using three
1/4 in. bolts as shown. Install the bolts and lock
washers through the un-threaded holes on the
bushing, and through the threaded holes on the
pulley.
NOTE:
It is very important to assemble
the pulley exactly as specifi ed. Failure to do so
may result in making it diffi cult to disassemble the
components in the future.
III.
A. Assemble the pulley to the axle as shown.
If the square key fell out of the axle during
disassembly, replace it and use it to align the
bushing’s key groove with the key on the axle.
NOTE:
Align outside of pulley to outside of
clutch brake pulley with a straight-edge. Failure
to do so could cause the slicer assembly belt to
come off during use.
B. Using a 7/16 in. wrench, tighten the 1/4 in.
bolts into the bushing. Take care to ensure that
the bolts are evenly tightened. Turn one bolt a
quarter of a turn into the pulley and then move
to the next bolt and tighten the same amount.
Keep alternating between bolts when tightening
until the bushing is completely tightened to the
pulley.
NOTE:
As it becomes more diffi cult to
tighten the bolts, reduce the amount of turning
that is applied to each bolt as you alternate.
Apply thread locker (such as Loctite) to set
screw for key, and tighten set screw.
26. Install slicer blade belt on pulley and engine sheave.
NOTE: Install idler pulley on inside of belt (see steps 7
and 8).
27. Turn bolt on the tensioner until the tensioner is set at
the 4th tick mark, and re tighten hex bolt.
28. Install pulley guards.
E. Replacing the Clutch Brake and/or
Transmission Belt
To replace the transmission belt you must fi rst
remove the clutch brake (see steps 1 to 11):
1. Disconnect spark plug.
2. Ensure that slicer control lever is not engaged.
A
A
B
A
3. Remove hex bolts (A) retaining left side belt cover (B)
and remove cover (B).
A
B
Hex bolt on other
side of Tensioner.
4. Loosen hex bolt retaining tensioner (B) to remove belt
tension.
5. Remove slicer drive belt (A) from the pulley and engine
sheave.
