REASSEMBLE REAR INTERNALS
STEP 1.
Join both Venturi Bolt and Striker Bolt thru the rear of the Receiver with the O-ring on the Striker
Bolt facing towards the front of the Marker. NOTE: When inserting both parts, apply finger pressure behind the
Venturi Bolt and at the same time pull on the Trigger to allow entry of the both parts.
STEP 2.
Insert the Striker Buffer flush at the lower end of the Receiver and place the Striker Spring thru the
Striker Buffer.
STEP 3.
Place the Striker Plug w / Velocity Adjuster & Spring Guide to the rear of the Receiver.
STEP 4.
Insert the Disconnect Pin to secure the Striker Plug in place. WARNING: Before/after use of the Marker,
make sure to fasten all screws. Screws may become loose due to vibration. Loose screws can be dangerous
and cause injury.
To assure marker is assembled properly, follow the schematic drawing or position parts in order during
disassembly. Parts assembled backwards or improper parts installed will / can cause the marker to malfunction.
WARNING: Never attempt to remove the markers internals while the CO2 / Compressed Air Tank is attached.
Make sure to remove all paintballs and loader before disassembling the marker.
BARREL SHROUD REMOVAL
STEP 1.
Using a 1/2inch or 13mm open end or and adjusted wrench loosen the Swivel End of the hose.
STEP 2.
Remove the Three Screws that hold the Trigger Housing to the Receiver. One the Screw is located at
the rear of the Receiver. The other Two additional Screws are on the Left and Right side of the Trigger Housing.
STEP 3.
Once the Trigger Housing is removed from the Receiver loosen all of the Six Screws from the Shroud.
This will allow the Shroud to split in half.
HELPFUL TIP: Please note how the parts are removed for easy reassembly.
English
8
