13
OUT OF RANGE Warning:
5 Talk back Indicator- Touch and hold ( ) on the monitor then talk back
to the camera, the talk back indicator ( ) will be shown on the LCD
screen. You must be viewing a single camera for the talk-back function to
operate.
6 Recording Indicator–"RECUR" appears when recording is in progress. If
viewing and recording video from multiple cameras at once, the recording
indicator will appear above each video display where recording is enabled.
7 Zoom Indicator-Press the Zoom button on the front panel of monitor to
enter (×2) mode, the indicator will be shown on the LCD screen. When the
zoom icon ( ) shows on the screen, you can use the joystick buttons
( ) to navigate to parts of the video that are outside the range of
screen. Press zoom again to exit zoom mode.
8 Overwrite Indicator –Indicates Overwrite mode is on, which means the
system will overwrite the oldest recordings when the memory card is full.
When you choose the overwrite function, the indicator will be shown on
the LCD screen.
9 New Record Indicator- Indicates that there are new recordings saved to
the microSD card that you are yet to play back.
10 Battery Indicator- Indicates the battery life of LCD monitor in low
battery will show red and the green LED under the indicator light will flash.
11 Time stamp-The current date and time on the system (month/date/year,
hour/minute/second)
12 Motion recording indicator- Indicates that motion recording is turned
on.
13 Volume indicator-Shows the current volume of the receiver. You must
be in single channel viewing mode to change volume. The mute symbol
( ) indicates the volume 0.
14 New download icon -( ) appears on the screen if new firmware is
available.
Viewing Modes:
There are four different viewing modes available on the system: single
channel viewing, Auto Sequence (Tour)
Viewing mode (view individual channels automatically in sequence), Quad
mode, and Scan mode.
Note: Auto Sequence Viewing mode cycles through connected channels in
full-screen. Use Quad mode to view up to four cameras simultaneously.
Use Scan mode, the receiver’s LCD screen and speaker will turn off unless
motion is detected by one of the cameras. The LCD screen turns on and
displays video from the camera where motion was detected for 15 seconds
before turning off again. This conserves battery power and alerts you only
when needed. You can configure how much motion is needed to turn the
display on in Scan mode by changing a camera’s video motion detection
settings. When exiting Scan mode, the receiver resumes live viewing in
Auto Sequence (Tour) Viewing mode.
To change viewing modes:
Press ( )view to select between Quad mode (half-Quad mode when only
2 cameras are connected) and Auto Sequence (Tour) viewing mode. OR
Press change channel icon to switch between channels 1-4 in single
channel view.
Quad Mode
Half - Quad Mode
USING THE SYSTEM
1DVRDIG1503
