10
p i c lt d .co m
To start J eepmeter
opErATIoNs
STEP 1:
Test the battery by placing the power switch to the “ON”
position. The light indicates good battery. If the light flickers or
does not come on, replace the batteries as described in the battery
procedure. Place the power switch to the “OFF” position after the
battery condition has been checked.
STEP 2:
To test DC holiday detector connect the high voltage (red
cable) test lead to the DC input terminal on the top left of the JeepMeter.
To test pulse holiday detector connect the high voltage (red cable) test
lead to the pulse input terminal on the top center of the unit.
STEP 3:
Connect the other end (alligator clip) of the (red wire) high
voltage test lead to a holiday detector electrode or the metal portion of
the electrode wand.
STEP 4:
Connect the ground (black cable) test lead to the ground input
terminal located on the top right of the JeepMeter.
STEP 5:
Connect the other end (alligator clip) of the ground (black cable)
test lead to the bare metal of the pipe if possible, otherwise to the bare
wire of the holiday detector ground cable. (Connecting to the bare pipe
gives a more accurate reading of the actual working voltage impressed
on the coating).
CAUTION!
TO PREVENT DAMAGE TO THE JEEPMETER, THE
INPUT PULSE / DC SWITCH MUST BE PROPERLY POSITIONED.
