Getting Started
9
Begin Self-Installation
When you power on your AIRAVE 3 LTE for the first time, it will go through an automated setup sequence.
NOTE
:
Each side of the AIRAVE has a set of LEDs specific to Data or Voice services.
1. During boot-up the device LEDs will be solid green for a few seconds during initial hardware tests.
This takes approximately 8 to 10 seconds.
2. The WAN LED on both sides will turn solid green; all other LEDs will be OFF. This takes
approximately 2 minutes.
3. The WAN LED on both sides will stay solid green; all other LEDs will blink red.
NOTE
: Steps 1 through 3 are expected behavior.
4. The NET LED on both sides will turn solid green. This will take approximately 15 minutes.
NOTE
: If the WAN or NET LEDs are solid red after 15 minutes, talk to your IT administrator to diagnose
problems with your internet connection.
5. This is a good time to take a break.
The device will go continue the self-installation process. During this time the device may download
software images and perform automatic synchronization between 3G and 4G services. The device
may also restart a couple of times.
Return after 60 minutes and check the LEDs on both sides. All LEDs should be solid green.
LED Label
Description when solid Green
WAN
Successful connection to the local LAN
NET
Successful connection to Sprint’s Core Network
GPS
GPS lock achieved
CDMA
3G CDMA Voice Services are available
LTE
4G Data Services are available
WIFI
WiFi Services are available
NOTE: If all LEDs are not solid green call Customer Care as described in
Getting help
.
