Make sure the transducer is aligned properly with the hole
in the pump manifold during reassembly. Improper
alignment may cause damage to the transducer gasket.
16. Thread the pump manifold mounting screws through the
pump manifold and into the gear box housing. Tighten
securely.
17. Reassemble the inlet valve assembly into the pump
manifold.
18. For Upright Cart units, thread the siphon tube into the inlet
valve and tighten securely. Make sure to wrap the threads on
the down tube with
PTFE
tape before assembly. Replace
the return hose into the hose clip on the siphon tube.
19. For Low Boy cart units, insert the elbow on the suction set
assembly into the bottom of the inlet valve housing. Push
the retaining ring up into the groove inside the inlet valve
housing to secure the suction set assembly in position.
Push the return hose onto the return hose fitting on the
pump manifold and secure in position with the return hose
clamp.
20. Place the front cover on the gear box housing and secure
in position using the four front cover screws.
21. Turn on the sprayer by following the procedure in the
“Operation” section of this manual and check for leaks.
NOTE: Repacking kit P/N 0551533 is available. For
best results use all parts supplied in this kit.
CAUTION
© SprayTECH. All rights reserved.
11
