Spotwave spotcell 100, User Manual, Page: 24 / 60

M
OUNTING THE
DU
AND
CU
18
SpotCell® 100 Series
4.4 DU indoor mounting
To mount the DU indoors:
1. Use the mounting bracket as a template and mark the hole locations. Mark the two
regular holes if no motion is required or mark the hole and the slot if motion is
required.
2. If the mounting is in a solid wood surface, or a stud covered by drywall, drill a 5/32
inch diameter hole. Mount the unit with 2 inch wood screws.
or
If the mounting is in drywall, drill a ¼ diameter hole and insert an anchor. Mount the
unit with 1/2 inch pan head screws.
3. Attach cables to the wall using tie wraps and mount directly to the wall where
possible (using 1/2 inch pan head screws). If an anchor is required drill a 3/16 inch
diameter hole, insert the anchor, and fasten with 1/2 inch pan head screws.
4.5 Mounting the CU
The SpotCell 100 series of products have two
different types of mounting systems.
The dual band product (SC141/142) uses a
mounting clip that is attached to the wall. The clip
must be mounted at least 4 inches from the ceiling
to allow the CU to slip into the bracket.
Figure 4.10: SC141/142
CU mounting bracket
All other SpotCell 1xx systems can either be
surface mounted flat or can be attached using the
optional ball bracket. The ball bracket can be
rotated to allow mounting to a ceiling or wall such
that the face of the unit is parallel to the floor or
ceiling, or positioned at any appropriate angle.
Figure 4.11: CU mounting bracket.
CU bracket