NETWORKEDIO FIRMWARE CONFIGURATION AND SETUP V4.0
©2019 SPOTTERRF 06.18.2019 REV001
SpotterRF Technical Support | 801.742.5849 x4 | [email protected]
3
3D Rotating Radar System Setup
Location
The 3D Rotating Radar System should be setup on an elevated platform or plane in reference to its surroundings. Do not
install the system in locations where there are large object impediments on the same horizontal plane to the radar’s field of
view (e.g. tall buildings, vehicles, tall trees, etc.). Always perform a proper site survey before any final installation in the
case that these large object impediments cannot be avoided.
Physical Setup
The 3D Rotating Radar System will come in a Pelican Air case with all necessary equipment for setup and a Quickstart
guide that is printed for reference. Quickstart guides can also be found on the SpotterRF Partner Portal. Mount the motor
base to the tripod and secure mount with accompanied nut (See image below). Mount radar to the motor’s alignment studs
and secure the mount with the two latches on each side (See image below). Connect the short GTC and GPS cables to the
radar and motor. Mount radar, motor, and base to the ball mount on the top of the tripod using the quick release plate.
Adjust the position of the radar using the ball adjustments. Hang the HUB5 from the carabiner with cable connections
facing down. Connect GTC cables as described on Networking page of Quickstart guide.
