background image

2

IMPORTANTWARNINGS AND INSTRUCTIONS

    Safety Information

BEFORE YOU BEGIN:

 Carefully read all instructions in this manual before assembling and using 

this product.The unit must be assembled by adults. Heavy duty working gloves should be worn to avoid 
injuries during assembly. 

READ ALL INSTRUCTIONS BEFORE ASSEMBLING OR USING THIS EQUIPMENT 

   
   
   

   
   
   
   

   

   

This product is intended for use by children ages 3-10 years.
On-site adult supervision is required at all times for children of all ages.     
Do not allow use by children with any physical condition that may affect his/her ability to use this 

Children must NOT play with this set until it is properly assembled and inspected by an adult. 

Do not allow children to climb on or jump off the play house.
Maximum 2 children inside playhouse at a time. 
DO NOT allow children under three years old nearby during assembly. Small parts may cause 
choking hazard.

Hardware:
Inspect all nuts and bolts and tighten if required. Hardware should be firmly against, but not 
crushing the wood. Over-tightening hardware crushes wood fibers and can split wooden 
components resulting in the bolt thread extending beyond the wood. This poses a severe safety 
hazard. If bolt threads protrude beyond the wood surface, replace the bolt with a shorter one that 
will not protrude. If splintering has occurred from over-tightening, larger washers can be 
purchased at your local hardware store and installed under the bolt head. Be sure to reuse or 
replace your lock washers.

Major Wooden Parts:
Inspect for structural defects and splintering. If necessary, lightly sand and refinish with an 
exterior water repellent stain. Seasonal checking or cracking of the grain on wooden parts is 
quite natural, water and heat are the most frequent causes of expansion and contraction of wood 
fibers. Our wood set has been treated with stain to resist weathering. But it needs to be 
maintained periodically by applying new stain or paint.

equipment safely. 

portant –Please read these instructions thoroughly before assembly or use.

Failure to follow these important requirements may result in the warranty being voided and/or 
serious injury. Please supervise your children carefully during the installation and assembly of the 
product. 

Please also pay close attention to the periodic maintenance that is required to keep your set in a 
safe condition for maximum enjoyment of backyard fun!      

Summary of Contents for PERSONALISED WOODEN PLAYHOUSE














Reviews: