STRIKE ATTACK™ SOCCER MACHINE
SPORTS ATTACK, LLC
•
800-717-4251
•
sportsattack.com
13
COMPONENT REPLACEMENT
(CONT’D)
DC MODEL CONTROLLER REPLACEMENT
1. Turn the power switch “OFF” and unplug the power cord.
2. Remove knob from the controller.
3. Remove four screws holding controller faceplate into main casting. Note the
position of the main power and motor wires on the controller, then disconnect
the wires. See Figure 12 for the two motor wires. See Figure 11 for the main power
cord wires.
4. Loosen the nuts holding the speed control shaft (potentiometer) to the faceplate,
then remove the controller.
Reassemble in reverse order.
Be sure wires are correctly reinstalled. Motor wire connectors are different sizes.
Be sure they are installed on the correct size terminal. See Figure 12 for the two
motor wires and Figure 13 for the power cord wires.
Black motor wires are
3
/
16
”
female disconnect and white
wires are
1
/
4
” female disconnect.
Component R
eplac
ement
Figure 13
CONNECTING WIRES
Motor Black
White
Wire Wire
Right
A-
A+
Left
A+
A-
WIRING
POWER CORD
White or Blue Wire (1)
To middle male terminal marked “N.”
Black or Brown Wire (2)
To circuit breaker.
Green Wire (3)
Grounds to machine/motor.
MOTOR WIRE LEADS
White
3/16”
wide connectors.
Black
1/4”
wide connectors.
Black Wire
(2)
connects to A-
on circuit board.
White Wire
(2)
connects to A+ on
circuit board.
CONTROLLER
Black Wire
(2)
2 PR jumper wire:
- 1 from on/off switch to
circuit breaker
- 1 from on/off switch to
circuit board terminal “L”.