STRIKE ATTACK™ SOCCER MACHINE
SPORTS ATTACK, LLC
•
800-717-4251
•
sportsattack.com
10
Component R
eplac
ement
Figure 9
Hold the wheel while
loosening bolts with a half inch
box-end wrench.
1/2” KEYWAY
RETAINING BOLT
LOCK WASHER
FLAT WASHER
KEY
MOTOR
THROWING
WHEEL
HOLES DRILLED
FOR BALANCE
COMPONENT REPLACEMENT
THROWING WHEEL REPLACEMENT
1. Turn both throwing wheel control knobs to “0.” If an AC unit, unplug the power cord.
Remove the 4 bolts on the outside wheel guard.
2. Hold the wheel so that it cannot move. Turn the keyway retaining bolt
counter-clockwise using a half inch box-end wrench (See Figure 9).
Suggestion: If the bolt is too tight, give the opposite end of the wrench a series of
light taps with a hammer making sure the wrench remains on the bolt.
3. Remove the bolt and washer.
4. Work the wheel off of the motor shaft. Be sure to catch the key as it is freed
from the keyway.
5. Ball throwing wheels are machine balanced. Small holes in the side of the wheel
are applied at the factory and are normal.
Reassemble in reverse order.
a. Install wheel to motor shaft with key slots aligned.
b. Be sure the key is in place, and inserted so that it is flush with the hub surface
at the wheel center.
c. Be sure the washer and lock washer are installed in the right order, and that the
keyway retaining bolt is tightened.
d. Test the wheel by spinning it by hand and making sure that it spins freely
without wobble before turning the unit on.
e. Be sure the top wheel guard is properly and securely reinstalled.
NOTE:
Check bolts for tightness once a season. Tighten bolts securely, but do
not over-tighten.