Sports Attack STRIKE ATTACK, Instruction Manual, Page: 14 / 17

STRIKE ATTACK™ SOCCER MACHINE
SPORTS ATTACK, LLC • 800-717-4251 • sportsattack.com
12
Component R
eplac
ement
CONNECTING WIRES
Motor Black White
Wire Wire
Right
A- A+
Left A+ A-
COMPONENT REPLACEMENT
(CONT’D)
AC MODEL CONTROLLER REPLACEMENT
1. Turn the power switch “OFF” and unplug the power cord.
2. Remove knob from the controller.
3. Remove four screws holding controller faceplate into main casting. Note the position of
the main power and motor wires on the controller, then disconnect the wires. See Figure
12 for the two motor wires. See Figure 11 for the main power cord wires.
4. Loosen the nuts holding the speed control shaft (potentiometer) to the faceplate,
then remove the controller.
Reassemble in reverse order.
Be sure wires are correctly reinstalled. Motor wire connectors are different sizes.
Be sure they are installed on the correct size terminal. See Figure 12 for the two
motor wires and Figure 13 for the power cord wires.
Black motor wires are
3
/
16
”
female disconnect and white
wires are
1
/
4
” female disconnect.
#3
#1
#2
Figure 13
Figure 11
Figure 12
WIRING
POWER CORD
White or Blue Wire (1)
To middle male terminal marked “N.”
Black or Brown Wire (2)
To circuit breaker.
Green Wire (3)
Grounds to machine/motor.
MOTOR WIRE LEADS
White 3/16” wide connectors.
Black 1/4” wide connectors.
Black Wire (2) connects to A-
on circuit board.
White Wire (2) connects to A+ on
circuit board.
CONTROLLER
Black Wire (2) 2 PR jumper wire:
- 1 from on/off switch to
circuit breaker
- 1 from on/off switch to
circuit board terminal “L”.
Circuit
Breaker
Black
Jumper
Wires
Bottom Motor
Black (A-) 1/4”
White (A+)
3/16”
Top Motor
Black (A-) 1/4”
White (A+)
3/16”
Power Cord
Black/
Brown
Green
(Ground)