TUNING REMOTE HANDSET TO REMOTE LAUNCHER
The Sport Grouse PRO launcher will come tuned in with your remote hand-
set, however if you are purchasing an add on grouse or if your batteries run
dead/completely flat you may have to tune/pair the remote handset to the
your remote launcher. You will require a phillips head screwdriver.
1.
Ensure the launcher is turned on. The rocker switch is red and the
green LED is illuminated.
2.
Undo the screws on the black box situated on the outside of the
launcher body tube and undo the screws on the back of the remote
handset.
3.
Remove the lids from both the launcher and handset carefully to
view the electronic board.
4.
Located at the bottom of the launcher board is a program/tuning
black button see images below. Press program/tuning button on the
launcher board until green light flashes.
5.
Wait 2 seconds then press several times the program/tuning button
on the back off the remote handset, a green light will flash on the
electronic board.
6.
Press and hold the button on the remote handset you would like to
program/tune launcher on, a LED green light will light on front of
remote handset. When LED stops flashing your launcher should be
paired with the remote handset.
7.
Replace the lids and screws onto both the launcher box and the re-
mote handset, and secure tightly.
See images over the next page to guide you with step by step process with
tuning/ pairing your remote launcher.
CHARGING THE LAUNCHER
The Sport Grouse PRO launcher is powered by 9.6V 2500mAh AA NiMH
Square (2x2x2) Transmitter RC Battery Pack which a rechargeable low self
discharge battery.
What is "Low
-
Self
-
Discharge" technology?
The term low self discharge means that the battery will not run down after
being charged anything like as fast as a conventional NiMH or NiCd
rechargeable battery would. After being charged, these batteries will
typically retain 80% of that charge after 6 months, and 70% after 12
months, ideal for Sport GrousePRO where they receive occasional use,
basically after being left for a couple of months you can just pick up where
you left off.
To charge, simply locate the DC female mount charging socket on the side
of the black box on the launcher body. Insert the charger
’
s DC male power
plug.
The charger supplied with your launcher is a Smart Charger, which can
distinguish 4~10 cells pack by MPU inside Automatically and cut
-
off the
charging accordingly. It is easy to use with a LED lito easily identify the
current charging status.
The status LED will glow Red when the
batteries are receiving charge. After
charge
is completed, the status LED will change
green to indicate that the
charge is
completed and batteries are ready for use.
Once the status LED is
Green, the charge
switches to trickle mode to keep the
batteries at full.
Important Safety Instructions
This charger is intended for use with only the Sport GrousePRO
’
s
rechargeable batteries only. Attempting to charge other types of batteries
may cause personal injury and damage to the charger.
Do not expose charger to rain or moisture. For indoor use only.
Remove from mains when not in use.
Never use an extension cord or any attachment not recommended by
manufacturer, otherwise this may result in a risk of fire, electric shock or
injury to persons.
Do not operate the charger if it has been subjected to shock or damage.
Do not disassemble the charger. Incorrect reassembly may result in a risk of
electric shock or fire.