SETTING UP
Make sure the ground the launcher is to fire from is suitable. Never fire the
launcher on over firm ground such as concrete, tarmac or stone surface, or
even very hard earth as damage to the launcher can be caused by the
recoil.
The lower leg sections are drilled with two holes, to allow use of metal pegs
to aid extra stability if required.
LOADING
Once you are happy with the launchers position then loading can begin (a
very small spray of lubricating oil e.g. Sporting Saint Dummy Launcher
Lubricant Spray onto the launcher seal will assist loading and the launching
operation).
1.
Slide on your launcher dummy onto the spigot.
2.
Open the head section by pressing the release lever and b) insert a
blank into the chamber.
3.
Close the head section gently, making sure the latch is fully engaged.
4.
Turn on the launchers main switch so you can see red in the plastic
window and the green LED will illuminate.
5.
Cock the launcher by pulling the cocking lever back and into the LH J
slot. Remember if the cocking rod is released for any reason when
pulling back as the launcher will fire so make sure you are clear of
the dummy, wearing ear and eye protection.
6.
To fire
-
turn on the handset switch, press the corresponding button
on the handset that operates the launcher. The solenoid will release
the cocking lever and the launcher will fire.
7.
Open the head section and pull it back slightly to operate the
extractor to lift the blank. Remove the blank.
8.
Shut the head section and begin procedure again
.
9.
Once you have finished, ensure the launcher is
TURNED OFF
to
preserve the battery life.
FREQUENTLY ASKED QUESTIONS
My Launcher Dummy is travelling too far?
Generally PVC launcher dummies will travel further than Canvas, if you are
wanting to reduce distance use a lower level blank or try a streamer
launcher dummy.
My Launcher Dummy is loose on the launcher head?
Try changing the o ring on the end of the launcher head as they will
deteriorate over time and the seal will reduce. Check and replace regularly.
I have pressed the ON/OFF rocker switch to ON but LED light is not lit up?
Try charging the unit as it sounds as though they are low, follows steps on
page 6 to charge the unit.
My Launcher is turned on and clicking, when trying to launch its not fir-
ing?
This generally means the batteries need charging, there is not enough
power to push the cocking lever to fire. See page 6 on how to charge your
launcher
My Launcher is turned on but when I press Launch button on handset
nothing happens?
Ensure remote handset is turned on, follow steps on page 9 to retune your
remote handset to your launcher.
When I press the Launch button on my remote handset, the green light
does not flash?
Ensure remote handset is turned on, If it is then replace the battery at the
back of the remote with a PP3 battery as originally supplied.