1. Position the SPS so that the plug reaches the wall outlet
2. Mark screw holes
3. Unplug the SPS
4. Use 5/16” or 8 mm drill bit to create drill holes
5. Push the supplied 5/16” x 1.5” (8 mm x 38 mm) anchors into the drill holes
6. Secure the SPS into anchors with supplied screws
Disclaimers
This product is intended for indoor use and must be protected from moisture and the elements to maintain
safety, durability, and preserve warranty coverage.
Note that power is prioritized to your dryer, so some special low-power dryer features (such as wrinkle
guard) may interfere with the operation of either your Tesla EV charger or your SPS unit, and therefore is not
supported or recommended. Contact
www.splitvolt.com/help
with any questions or for more information.
This product is designed to operate at a maximum continuous electric vehicle charging rate of 24 amps on a
standard household 30-amp circuit.
According to the National Electrical Code (NEC), exceeding this rate is
unsafe. It can trip the Splitter Switch internal safety circuit breaker, cutting off power, in order to reduce risk
of damage or risk of fire. Contact an electrician if you ever have questions about local safety codes, or if you
are unsure of the condition of your wiring.
DO NOT DISASSEMBLE. OBSERVE ALL WARNING LABELS. Do not remove warning labels.
Connect to a properly rated, protected, correctly sized power circuit which has been installed to local safety
code standards.
If an electrical supply line, connectors, or other circuit elements are worn or damaged, do not use and
consult a qualified electrician. The Splitvolt Splitter Switch is intended only for use with electrical circuits and
wiring that is in good condition and meets local building safety codes.
6
Splitvolt, Inc.
