5
How to Hang
This Ceiling Fan
WARNING
The fan must be hung with at least 2.1m of
clearance from
fl
oor to blades. (Figure 2)
WARNING
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or
fi
re hazard.
WARNING
To avoid possible shock, do not pinch wires between
the hanger ball assembly and the hanger bracket.
WARNING
To avoid possible
fi
re or shock, be sure electricity is
turned off at the main fuse box before wiring.
(Figure 1)
Figure 2
CEILING
FLOOR
Figure 4
Figure 3
Figure 1
MAIN FUSE BOX
Motor Assembly
2.
Carefully lift the motor assembly on the hanger
bracket that was just attached to the timber batten.
Be sure the groove in the ball is lined up with tab on
the hanger bracket (Figure 4).
NO
LESS THAN
2.1 M
Hanger
Bracket
Note: Ceiling board and
wiring omitted for clarity.
Screw with hex head
screws(2) supplied with fan
Hanger
Bracket
Terminal Block
Tab
Note: Ceiling board and
wiring omitted for clarity.
Timber Batten
WARNING
The hanger bracket must be securely mounted and
capable of supporting at least 27 kg. If bracket and /or
timber batten are not securely attached, the fan could
wobble or fall.
1.
Drill a hole in the ceiling board and batten for wiring
Securely attach the hanger bracket to a timber batten
or other structural support using appropriate fasteners.
(Figure 3).
Note:
Before assemble the hanger bracket, please
remove both of terminal blocks. Reassemble the
terminal blocks when the hager bracket assembled
completed.
Summary of Contents for MA6720 AU series
Page 12: ...2014 09 V 01 ...
