SPIT AC 1630P, Operating Instructions Manual, Page: 15 / 220

15
13 Repair
l
WARNING!
Improperly repaired vacuum cleaners pose a hazard for
the user!
▶ Have repairs carried out by qualified personnel only, e.g. the
customer service.
14 Troubleshooting and repair
NOTE
Malfunctions cannot always be traced back to defects in the vacuum cleaner.
Fault
Cause Remedy
Suction power drops Filter dirty Clean
Filter bag full Change
Container full Empty
Motor protection filter blocked Clean
Nozzle, tube or hose blocked Clean
Vacuum cleaner does not start Mains plug not in socket Plug mains plug into socket
No mains voltage Check fuse
Mains connection cable defective Replace
Cover not properly closed Close
Water sensor switched off Empty container
Vacuum cleaner in standby mode >A<
or >AC<
Set switch to >I< (see „3 Display and control
elements“ )
The vacuum cleaner does not start
when the tool is switched on in the >A<
or >AC< mode
Electrical tool not plugged into socket
on the vacuum cleaner
Plug mains plug into socket on the vacuum cleaner
Solenoid valve of pneumatic on-off unit*
contaminated
Rinse with alcohol
PE emptying and disposal bag is sucked
against the filter
Incorrect position of rotary slide Set rotary slide to position OPEN ▲(see „7.4 Insert
PE emptying and disposal bag*“ )
Vacuum cleaner with dust classes M
or H : with inserted filter bag, dust is
accumulating in the container
Incorrect position of rotary slide Set rotary slide to position CLOSE ▲ (see „7.3
Insert fleece filter bag“ )
Do not try anything else, contact customer services.
780399_V00_2019-05_GA_ISP.indb 15 02.10.2019 16:52:14