XBR25 / XBR55
17
STEP 3: SEAT & HANDLE BAR ASSEMBLY
1. Install the Seat Cushion (61) on the Seat Carriage (4) with the four M6x15mm Phillips Head
Screws (98).
2. Install the Handle Bar (6) onto the Seat Carriage (4) with the four 3/8 x 1-3/4 Hex Head Bolts (71),
four 3/8 x 19 Flat Washers (77), and four 3/8 x 7T Nylon Nuts (89) by using the 12/14mm Wrench
(112).
3. Plug the two Hand pulse Cables (27-3)(27-4) and the switch cable (26) into the sockets located on
the left side rear cover, just under the seat. Two of the plugs look the same; these are the hand
pulse plugs and can be plugged into either hand pulse socket. The three socket connectors on the
side case below the seat have two that are the same also. The odd plug and socket is for the
switches in the handlebars.
4. Install the Front Stabilizer Cover (32) and the Rear Stabilizer Cover (37) on the Main Frame with
the four M5x12mm Phillips Head Screws (99).
