73
RPM SENSOR TEST
Purpose of this setting is to test the functionality of the RPM detection system.
•
Press PLAY KEY to enter RPM SENSOR TEST.
o
REED ON RPM displays ON or OFF.
o
When REED Switch is Closed, displays ON.
o
When REED Switch is Open, displays OFF.
•
Press PLAY KEY to exit to setting screen.
•
Press + KEY for next screen or RESET CONSOLE to exit MAINTENANCE MODE.
UPDATE SOFTWARE
NOTE:
Updating Software requires a Blank USB memory stick and a computer to transfer updates from
service website.
•
USB port is located underneath the console.
•
Press PLAY KEY to display BOOTLOADER – OFF.
o
Press + KEY or – KEY switch to BOOTLOADER – ON.
o
Allow console to Power Down.
o
Wait until console has Turned OFF.
Powering down could take up to 10 minutes if bike
had been ridden for a time before updating
software.
o
Insert the USB drive, wait 1 to 2 minutes.
o
Pedal bike to awaken console.
If successful, displays UPDATE DONE.
If unsuccessful, displays UPDATE FAIL, check USB for proper insertion and
attempt again.
•
Press PLAY KEY to exit to setting screen.
•
Press + KEY for next screen or RESET CONSOLE to exit MAINTENANCE MODE.
LED BRIGHTNESS
Purpose of this setting is to change the brightness of the display.
•
Press PLAY KEY to change setting.
•
Default brightness setting is 2.
•
Press + KEY or – KEY switch between LED Brightness 1, 2, or 3.
•
Press PLAY KEY to accept and exit to setting screen.
Summary of Contents for JB 950
Page 36: ...36 EXPLOSIONSZEICHNUNG ...
Page 78: ...78 EXPLODED VIEW DIAGRAM ...
