Spirit Fluid Rower 900 Series, Owner'S Manual, Page: 40 / 46

40
Troubleshooting
Fault Probable Cause Solution
Water changes color or
becomes cloudy.
Rower is in direct
sunlight or has not had
water treatment.
Local tap water is of poor
quality.
Change rower location to reduce direct
exposure to sunlight. Add water
treatment or change tank water as
directed in the water treatment section
of this manual. Consider using distilled
water to refill tank.
Rower Belt slipping
off belt/ bungee
pulley.
Bungee not under
enough tension.
Recoil not strong
enough
Tighten bungee cord following the
instructions in "reattaching the
rower belt" section of this manual.
Inconsistent readings on
the Rower Computer for
500meter split time and
SPM (strokes per
minute).
Sensor gap
Faulty Sensor
Sensor has moved out
of position
Wiring harness
Use the back cover of the computer as a
“Gap tool” to check the gap between
sensor head and Magnetic ring, or see if
the Sensor head has moved out of
position.
Please contact your nearest SPIRIT
customer service center for details
The Rower Computer
does not illuminate
after battery
installation.
Batteries installed
incorrectly or need
replacing.
Replace/reinstall batteries in
correct position and try again. If
the LCD screen fails to illuminate,
try rotating the batteries slightly in
the computer. If this fails, contact
your local service center.
The Rower Computer
screen illuminates, but
does not register when
rowing. Loose or failed
connection.
Sensor gap too wide
Check that the computer lead is
connected properly. If it is connected
then contact your local service center.
Check Sensor gap.
※
Please contact your nearest SPIRIT customer service If any required.