Spirit Fluid Rower 900 Series, Owner'S Manual, Page: 21 / 46

21
Assembly Instructions
STEP 1 Installing the Rear Brace and Transport Wheel Assembly to Seat Rail
S
TEP
a )
Start with the Rear Brace and on the underside you
will find a Pre-installed bolt . From the hardware kit,
take the Bungee Hook Mount and install it onto the
Rear Brace as shown. Note the orientation of the
Brace and hook must be correct in order to hold the
end of the
Bungee Shock Cord as depicted by the
arrow in the illustration, which points toward the front
of rower.
b )
Next, connect the Side Rail Left and Side Rail Right
[2] using 4x M6x15mm Bolts[10] and Rear
Brace[4] .
DO NOT TIGHTEN.
Tip: Bump stops facing inside of rail for correct
assembly orientation.
c )
Once the Rear Brace and Side Rails are
assembled, mount the Transport Wheel
Assembly[6] onto the Left/Right Side Rails[2] .
Note: One washer on outside and one washer on the
inside of the side rail.
WARNING
Rotate Rear Brace to correct
orientation before assembly
onto Side Rails
REQUIRED
Side Rail Left / Right [2]
Rear Brace [4]
Bungee Hook Mount [5]
Transport Wheel Assembly [6]
4x M6x15mm Bolts [10]
Towards Front of Rower
Rear Brace (Underside)
Bungee Hook Mount
Pre-installed Bolt
WARNING
Note Transport wheels must be
mounted on the outside of Side
Rails As shown on the right.
Do not over tighten the Transport
Wheel Axle as it may inhibit
Transport Wheel rotation
.
Transport Wheel Assembly
M8 x 60mm Bolt
M8 Washer
M8
Washer
Transport Wheel
M8 Nylon Nut
Side Rail Right
Bump stop
Side Rail Left
Rear Brace
M6x15mm Bolts
*Bungee Hook Mount
towards to the floor