Spirit Fluid Rower 900 Series, Owner'S Manual, Page: 27 / 46

27
Heart Rate Installation Instructions
1. After confirming all parts are present. Find the flying lead
on the Mainframe of the rower just behind the upper
Footboard and attach the harness.
2. Run the wire under the Footboard to the side rail.
3. To paste the HR receiver to the location as indication label
by double-sided tape, and please be aware on the direction,
keep the wire in the downside.
Note: Don’t affix permanently until signal In this location is
tested. Mount the Receiver low enough to avoid the lower
Seat Rollers.
4. Use the wire placement pads to secure the wiring out of the
way of any moving parts. Trim excess.
Note: You will have an excess of wire which you can tuck out of the way behind the metal frame bracket as shown.
Notes: Maintaining a consistent signal on a rower can be a challenge due to the varying distances experienced during the rowing stroke
between the Receiver/Transmitter.
If you are experiencing difficulty, make sure the batteries on your chest belt or other device are fresh, and that the frequency of your
transmitter is 5.3 KHz.
Environmental conditions, as well as proximity to other machines can also interfere with a clean signal. Feel free to experiment with
different locations for best performance.
- Heart Rate Receiver 5.3KHz x 1 pc
- Cable tie x 3 pcs
- Cable tie mount x 3 pcs