Customer Service 1-888-707-1880
Dyaco Canada Inc. 2021
Email: [email protected]
41
GENERAL MAINTENANCE
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking, or rough feeling develops, the main cause is most likely one of two
reasons:
a. The hardware was not sufficiently tightened during assembly. All bolts that were
installed during assembly need to be tightened as much as possible. It may be
necessary to use a larger wrench than the one provided if you cannot tighten the
bolts sufficiently. I cannot stress this point enough; 90% of calls to the service
department for noise issues can be traced to loose hardware.
b. The crank arm nut needs to be retightened. If squeaks or other noises persist,
check that the unit is properly levelled. There are 2 levelling pads on the bottom of
the rear stabilizer. Use a 14mm wrench (or an adjustable wrench) to adjust the
levelers.
WARNING
The effect that the safety level of the equipment can be maintained only if it is examined regularly
for damage and wear.
i. Replace defective components immediately and/or keep the equipment out
of use until repair.
ii. The components which are most susceptible to wear: Belt
、
PU wheel
、
Bearing
、
Idler.