IM-P357-29
CTLS Issue 14
24
5.2.2 Spring kit - How to fit:
Note:
Items
9
and
28
do not apply to the PN9400 actuator.
-
Remove the actuator from the valve as described in Section 5.1.
Note:
Please observe Note 1, above. Refer to Section 5.4 if a handwheel is fitted.
-
Lubricate the threads of the three long hex. head screws with a PTFE based grease
before releasing the tension in the springs.
-
Loosen and remove the short housing screws and nuts (
22
,
23
and
24
).
-
Holding each nut with a spanner, rotate the three long hex. head screws a few turns at
a time. Remove the screws and upper housing (
2
).
-
Replace with new springs. While supporting the actuator spindle (
6
) so that the
diaphragm sits evenly in the lower housing, refit the top housing (
2
) and tighten the
screws evenly. Please observe Note 2, above. Refer to Section 5.4 if a handwheel is
fitted.
Table 1 Recommended tightening torques
Actuator
series
Screws and nuts
(Items 22
,
23 and 24)
Bolt
(Item 21)
Size
Torque
Size
Torque
N m
lbf ft
N m
lbf ft
PN9100
M6
7
5.2
M12
40
29.5
PN9200
M10
35
26.0
M12
40
29.5
PN9300
M10
35
26.0
M12
40
29.5
PN9400
M10
60
44.0
M16
40
29.5
Summary of Contents for PN9120
