IM-P402-129
EMM Issue 7
11
Note: Read the 'Safety information' in Section 1 before installing the product.
The product must be installed in a suitable industrial control panel or fireproof enclosure
to provide impact and environmental protection. A minimum of IP54 (EN 60529) or Type 3,
3S, 4, 4X, 6, 6P and 13 (UL50/NEMA 250) is required. If installed in a harsh environment
(conductive dust and / or wet conditions), extra protection is required.
During installation or maintenance, the rear of the product
must
be protected from
environmental pollutants entering the product. Alternatively, the tasks can be performed in
a dry clean environment.
Caution 1: The product must only be installed in the vertical orientation.
Caution 2: Do not cover or obstruct the infrared beam between products.
Ensure that the display can be easily read by the operator.
Warning:
The boiler control panel or enclosure doors must be kept closed at all
times unless installation or maintenance work is being carried out.
4.1 Environmental conditions
Install the product in an environment that minimises the effects of heat, vibration, shock and
electrical interference (see Section 1
-
'Safety information').
Do not install the product outdoors without additional weather protection.
Do not attempt to open the product
-
it is sealed and has no replaceable parts or
internal switches.
4.2 Installation on a DIN rail
The product is provided with a clip and a set of self-tapping screws to secure it to a 35 mm DIN
rail. On the rear of the enclosure, two sets of holes are provided to give two height positions.
The clip can be adjusted to give further positions. Locate the clip onto one set of holes and
secure it using the two screws provided. Ensure the spring clip is fully engaged with the rail.
Warning:
Only use the screws provided with the product.
4. Mechanical installation
Summary of Contents for LC1350
Page 35: ...IM P402 129 EMM Issue 7 35...
Page 36: ...IM P402 129 EMM Issue 7 36...
