Lacing the Bobbin
Remove the orifice bar and
place a bobbin on your flyer.
Place the orifice bar on, and
attach a leader thread to your
bobbin. Lace the bobbin by
allowing the leader thread to
fall below the bobbin. Take the
leader thread under the curve
of the PaulyWinder on the
right to the outside of the
PaulyWinder. Then take the
thread and place it on the
fulcrum pin. Then lace the
thread thru the loop or hook of
your PaulyWinder. Then lace
the thread thru your orifice. See photo below for reference.
Spin and Adjust Tension
Spin under a yard of yarn in a clockwise direction and adjust your tension as needed for
the uptake you prefer. Before continuing, set the starting point below.
Set the Starting Point
Now that you have yarn on the PaulyWinder, you can adjust the
starting point. You will notice there are angle marks along the outside
of the PaulyWinder. Always start a new bobbin with your yarn down
the center (90 degree angle) of the PaulyWinder from the fulcrum
point. If your yarn is in front of the 90 degree angle, tighten the black
screw to push the fulcrum pin backwards so the center of your yarn
runs along that center line. This will help the PaulyWinder fill your
entire bobbin from front to back.
