on the magnets. If your orifice bar does not go onto the flyer, confirm that you have the
balance bar installed with flat side (right above the magnet) facing upward. After you
have aligned the PaulyWinder by putting the orifice bar on, tighten the screws on the
back of the flyer to secure the alignment.
Note: Never treadle the PaulyWinder without the orifice bar. This will cause damage to
the PaulyWinder.
Installing the Fulcrum Pin
Next, install the fulcrum pin. Place one
washer on the screw, and place the screw
thru the hole at the top of the post. Place
another washer on the silver screw that is
poking thru the hole in the post and secure
by hand-tightening the pin onto the screw
as pictured. Do not over tighten. The pin
should be placed close to the spinner,
resting against the black alignment screw
in the PaulyWinder. Note: when you begin
to use the PaulyWinder you will adjust the
fulcrum pin with the black alignment
screw if your yarn is not being wound all
the way to the back of the bobbin.
Installing the Gates
The gates are installed with the curves
facing the outside and the flat sides facing
each other as pictured. Squeeze the gate
piece and slide it into the gate groove
along the side of the PaulyWinder until it is
at the back of the groove. Squeeze the
second gate piece and slide it the gate
piece so it is at the front of the groove.
