PaulyWinder Installation Guide
Removing the Flyer Bars:
1. Remove the orifice bar and the bobbin from your
flyer.
2. Uninstall your flyer bars by unscrewing the two
screws behind the flyer head that secure the flyer
bars into the head. These screws may be square or
phillips head.
3. After removing the screws, pull or twist the bars to
remove them from the flyer head. It is common for
the bars to be securely fit into the flyer head.
Note: If your wheel model is not Golden Whorl, there may
be additional assembly required. Before continuing with
additional disassembly, inspect your flyer to see if your
PaulyWinder and screw kit can be used without further
disassembly. If your flyer has too much depth to install the PaulyWinder, you will need
to remove either the ring or the triangular wooden points as described below:
●
If your Flyer head measures 1.5
inches deep, you will need to
remove the four screws and the
wooden ring (.5 inches) from the
face of your flyer to install the
PaulyWinder.
●
If your flyer has triangular wooden
points (see picture), you may need
to remove these when installing the
PaulyWinder.
