SPINNER® BL ADE AND SPINNER® BL ADE ION
OWNER’S MANUAL
www.spinning.com 800.847.SPIN (7746)
17
2. Turn the assembly over and slide the top
portion rearward so that the limiter screw hole
is exposed as shown. Now insert the small 3mm
bolt into the exposed hole and tighten. This
bolt sets the travel limit of the slider.
3. Attach the seat slider end cap using two bolts
and fully tighten with the supplied allen key.
STEP 5:
INSERT THE SEAT POST
1. Hold the seatpost in one hand and the pop-
pin with the other. Insert the seat post into the
frame and tighten the pop-pin.
2. Unscrew the knob of the pop-pin and then
pull back on the spring loaded handle.
3. Insert the seatpost into the seatpost glide
and find a general location that lines up with
the pop pin.
4. Now release the lever and pull up or
push down on the seatpost until the pop pin
engages a hole in the seatpost.
5. Tighten the pop pin by turning the handle
clockwise to secure the seatpost.
STEP 6:
HANDLEBAR ASSEMBLY
1. Hold the headpost in your hands and slide the
handlebar assembly onto the handlebar post
by loosening the fore/aft handlebar knob and
pulling it up to align with the grooves on the
handlebar post.
2. Insert one 3mm bolt into the post on either
side and fully tighten it to set the travel limit.
3. Attach the handlebar post end cap using one
3mm bolt and fully tighten with the hex key.
4. Tighten the fore/aft adjustment knob in any
position before proceeding.
3
2
1
2
3
5
6
