© 2021 Mad Dogg Athletics, Inc. All rights reserved.
16
SPINNER
®
BIKE ASSEMBLY
STEP 1:
UNPACK THE CARTON
Open the shipping carton as illustrated on the box and remove all of
the parts. Make sure that the following parts are included and that no
damage has occurred during shipping:
• Bike frame with flywheel
• Front stabilizer bar with
transportation wheels
• Rear stabilizer bar
• Handlebars
• Handlebar stem
• Left Side Crank
STEP 2:
ATTACH THE STABILIZER BARS
Have someone help you tilt the bike forward
(toward the flywheel), remove the rear plastic
shipping guard, then you can attach the
rear stabilizer bar from the underside with
the provided bolts and washers. Line up the
holes in the stabilizer bar with the holes in the
frame. Using the included wrench, tighten
the bolts (with washers) securely. Repeat the
process with the front stabilizer bar.
STEP 3:
INSTALL THE SEATPOST POP PIN
Install the seat post pop-pin and tighten the
bolt securely making sure that the thin washer
is properly seated and centered between the
pop-pin and the frame boss.
STEP 4:
ASSEMBLE THE SEAT POST
1. Slide the seat assembly onto the seatpost,
insuring that the black internal glides remain in
place and are secure inside the slider.
If the glides have slipped out, please make sure
to reinstall them. The glides are shaped to fit in
the orientation as shown and must be installed
by sliding them into the groove from the outside
edge in the correct orientation.
1
2
3
4
1
• Pedals
• Pop pin assembly seat
• Seat slider and saddle
• Seat post
• Tools for assembly and maintenance
provided on the parts card.
• Owner’s manual
