122PB UNEVEN PRO BARS ll
Assembly Instructions
Page 7 of 11
Figure 2
1.3. Width Adjusters Assembly
1. Unscrew the width adjusters mounting hardware from the studs on the uprights. Install the width
adjuster as shown on Fig. 2 below, and secure with mounting hardware.
1.4. Raising the Uneven Bars
1. Prepare to raise the uprights and width adjusters assembly and attach rails to the uprights:
Partially unscrew the safety screws on each adjusting tube swivel head (See Fig 3 below).
Have a rail within
arm’s reach of each set of uprights.
Layout tie-down system as per tie-down instructions and open quick links that connect cables
to the uprights.
Prepare a ladder to attach cables and rails to the uprights.
Keep in mind that during this stage of the apparatus assembly, the sides of the uneven
bars are
NOT
supported and must be held by one person on each side. A third person is
required to attach the rails and connect the cables.
Figure 3:
Rails to Uprights Assembly
