Sperry Marine NAVIKNOT 600 SE, Operation, Installation And Service Manual

Page: 83 / 138

NAVIKNOT 600 SE 056349/C
GPS Setup 6-27
R/P Offsets
Sets the correction values for misalignment of the PCB with the roll and
pitch axes.
As roll and pitch angles from the satellite PCB are not evaluated in the
NAVIKNOT 600 SE system, the R/P offsets are not applicable.
Do not alter the factory default settings (roll and pitch delta = 0.0°)
Mag at Sea Cal.
Calibrates the magnetic heading sensor on the satellite PCB.
The magnetic heading sensor contained on the satellite PCB is not suita-
ble for use within the NAVIKNOT 600 SE system. Therefore it must not
be calibrated.
Do not carry out the Mag. at Sea Cal. procedure. Leaving the sensor in
the uncalibrated state will prevent it from being activated by accident.
Port D Output Sel.
Configures the data output port D on the satellite PCB.
The satellite PCB’s outputs to external equipment are not used in the
NAVIKNOT 600 SE system.
Do not alter the factory default setting (port D output = NMEA)
NMEA Output Sel.
Configures the NMEA heading data output sentence at ports C, D and H
on the satellite PCB.
The satellite PCB’s outputs to external equipment are not used in the
NAVIKNOT 600 SE system.
Do not alter the factory default setting (all ports set to HDT)
Version Number
Displays the version number of the satellite PCB software.
Settings: none
the version number page is read-only.