- 8 -
F. Temp Unit Default Setting
Press the
SET
button (8) as needed to reach "temp. unit" screen.
Use the
▲
UP
(5) and
▼
DOWN
(6) buttons to switch between
°F and °C. Press the
ENTER
button (4), then press the
ESC
button (3) to save the setting and exit this function.
G. Escape from Advanced Adjustments
For the above procedures (B through F), press the
ESC
button (3) before
pressing the
ENTER
button (4) to exit advanced adjustments without sav-
ing the changes.
5. UPLOADING DATA FROM THE METER
To upload the data to a computer, connect the RS232 cable and run the
software (pg 10). You can only send one memory block at a time.
First, cancel the HOLD and RECORD functions if they are activated.
Press the
SEND
button (7) for at least 2 seconds until the bottom right dis-
play shows "Transmit mode." Release the button. The following screens
flash alternately:
The meter can record up to 16,000 data points, stored in a maximum of
250 memory blocks. All data points saved during one data logging ses-
sion are stored in one memory block.
Data 1 Data X+1 Data Z
To Data X To Data Y To Data 16,000
Use the
▲
UP
(5) and
▼
DOWN
(6) buttons to select the desired memory
block number (1 to 250) and push the
SEND
button (7) once. The bottom
right of the display shows "Sending Data!". When the process has fin-
ished, "Transmit mode" is displayed. Push the
ESC
button (3) to exit this
function.
Block 1
Block 2
Block 250
………
………
1 = °F
0 = °C
75.34
%RH
xx:xx:xx Transmit Mode
1
%RH
1 Transmit Mode
start time the first data memory block start data address
of each block of each block number of each block (1-250)
