Spellman High Voltage Electronics Corporation One Commerce Park,
Valhalla, NY 10595, (914) 686-3600, Fax: (914) 686-2870
Since this is an ASCII string it may be printed directly to the CRT or printer. After receiving the ‘T’
command the 200-C488 will return a character string containing the output status (Normal, Tripped or
Shutdown) and the voltage and/or current readings in the same numerical format as is used to enter voltage
and current values. Below are the ‘T’ commands with representative measurement strings that would be
returned from the 200-C488.
T0
‘N Vxx.xxxK
Ix.xxxxM’
T1
‘N Vx.xxxxK’
T2
‘N Ixxx.xxU’
Where the ‘N’ in the string means the output is on. It may be replaced with an ‘S’ that means the output
was shutdown by user with an ‘Z’ command or device clear bus command, or a ‘T’ in that means the output
was tripped due to an overload detection where:
‘V’ in the string means voltage
‘I’ in the string means current
‘K’ in the string means kilovolts
‘M’ in the string means milliamps
‘U’ in the string means microamps
SECTION IV MAINTANENANCE
4.1
GENERAL
The 200-C488 interface should not require any maintenance or calibration. It is designed for
reliable, trouble free operation. If any question should arise, contact the Spellman Customer
Service Department for assistance or return authorization. Although adequate information is
provided in this manual, it is suggested that the unit be returned to the factory if service should
become necessary.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
