Washer Symptom
Possible Cause/Solution
Left Decimal Point blinking on display
one second on/one second off
• This code indicates that the washer did not reach the maximum intended speed in
the final spin.
• This could be due to an unbalanced load, excessive suds in the load, or too much
water left in the tub due to slow draining.
• Be sure to use proper load sizes that are evenly distributed in the wash basket.
• Be sure to use high efficiency (HE) detergent.
• Open the lid or press any keypad to clear this code.
PF
on digital display
• This code will be displayed if the control was in Delay Start Mode when a power
failure occurred.
• The delayed start will be canceled.
• Press the Power/Cancel Pad to clear the code.
Er
,
SL
on digital display
• This code will be displayed after a cycle for one minute, or until the Power/Cancel
keypad is pressed, and indicates an oversudsing condition.
• Laundry load may be oversudsing. Make sure you are using low sudsing, high effi-
ciency (HE) detergent. If using non-HE detergent, use only 1/2 of the detergent
manufacturer's recommended amount.
• Laundry load may be overloaded. Make sure you are using proper load sizes.
Sr
, cycle time remaining on digital
display
• The control has detected an oversudsing condition and is running a special routine
to remove the excess suds.
Other
Er
or
Ed
Codes
• If the control displays any other
Er
or
Ed
codes, unplug the machine for 15 sec-
onds. Plug the machine back in. If code still appears, call for service.
Troubleshooting
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
32
Part No. 203967ENR3
Summary of Contents for TR7003WN
Page 2: ......
