Washer Symptom
Possible Cause/Solution
Er
,
FL
on digital display
• This code will appear if the washer has not reached the fill level after 30 minutes
during a wash or rinse fill.
• Make sure hot and cold water faucets are turned on.
• Make sure that the fill hoses are not kinked or twisted.
• Clean the screens in the water mixing valve and the filter screens located at the
faucet end of the fill hoses.
• Unplug the machine for 15 seconds to clear this code.
Er
,
dr
on digital display
• This code indicates that water is still in the washer at the end of the cycle.
• Check the drain hose and drain receptacle to make sure they are installed properly
and not blocked.
• Unplug the machine for 15 seconds to clear this code.
Er
,
PS
on digital display
• The control has detected trouble sensing the water fill level.
• Unplug the machine and call for service.
Er
,
Lo
on digital display
• The control senses that the lid is open during a running cycle.
• Unplug the machine to clear this code.
Er
,
LL
on digital display
• The control senses that the lid has unlocked during a running cycle.
• Unplug the machine to clear this code.
Er
,
nF
on digital display
• The washer has not filled to the proper water level.
• No or very little change in water level has been sensed within 5 minutes of the cur-
rent fill.
• Make sure hot and cold water faucets are turned on.
• Make sure that the fill hoses are not kinked or twisted.
• Clean the screens in the water mixing valve and the filter screens located at the
faucet end of the fill hoses.
• Unplug the machine for 15 seconds to clear this code.
Er
,
OF
on digital display
• This code indicates the washer has filled to the overflow level.
• The machine will begin to attempt to pump water out if the lid is closed and locked.
• If the code does not clear, unplug the machine and call for service.
Er
,
LU
on digital display
• The control senses that the lid will not unlock.
• Unplug the machine for three minutes to unlock the lid.
• If the code appears again, call for service.
Er
,
Ll
on digital display
• This code indicates that the lid has not locked.
• Make sure the lid is closed all the way and try to start the cycle.
• Open the lid or unplug the machine to clear the code.
• If this code continues, call for service.
Table continues...
Troubleshooting
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
31
Part No. 203967ENR3
Summary of Contents for TR7003WN
Page 2: ......
