Page 9
OPERATION
WARNING: See safety information related to operation of the log splitter on page 3 and 4 of this manual. Make sure that you have the
recommended personal protective equipment described on page 1.
1) Set up the log splitter in a clear, level area and block the wheels. Make sure that the suction port on the tank is always on the lower side
of the log splitter.
2) Place a log on the beam against the wedge. Make sure the the log is securely on the beam and up against the wedge.
3) With the engine running, depress the valve handle so that the cylinder will drive the ram into the log. Extend the cylinder until the log splits or
to the end of its stroke. If the log has not completely split after the cylinder has reached the end of its extension, retract the cylinder.
IMPORTANT: Leaving the valve in the “actuate” position at the end of the stroke may damage the pump. Always use extra care
when splitting logs with unsquare ends.
TOWING
MAINTENANCE
1) Consult the operating and maintenance instructions of the engine manufacturer for engine care and maintenance.
2) Always check the oil level of the hydraulic reservoir before operation. Operating the log splitter without an adequate oil supply will cause
severe damage to the pump.
3) Clean the suction filter after the first 25 hours of operation. Thereafter, clean the filter every 100 hours or seasonally, whichever comes first.
4) To drain the hydraulic oil from the tank, loosen the hose clamp (11) and remove suction hose (12). Refer to illustration 1 on page 10. We
recomend that the suction filter (19) as shown in illustration 2 on page 11 be removed and cleaned at this time.
5) If excessive clearance is found between the push plate (3) to beam mount, loosen push plate bolts and adjust the middle plate to approximately
1/8 in. gap on each side. Retighten bolts securely. Do not adjust plate too tightly or damage may result. Refer to illustration 2.
6) See also Repair and Maintenance Safety on page 4 of this manual.
7) All replacement parts must meet manufacturer’s specifications.
NEVER
tow this log splitter on a road or highway. Serious injury and/or damage could result.This log splitter may be
towed off road behind an ATV or lawn tractor. Low speed towing is strongly recommended.
