KNOW
how to stop the log splitter and disengage the controls before operating it.
NEVER
place hands or feet between the log and splitting wedge during forward or reverse stroke. Serious injury or death
could result.
NEVER
straddle or step over the log splitter during operation.
NEVER
reach or bend over the log splitter to pick up a log.
NEVER
try to split two logs on top of each other.
NEVER
try to cross split a log.
NEVER
attempt to load your log splitter when the ram or wedge is in motion.
ALWAYS
use your hand to operate the control lever on the valve. NEVER use your foot, a rope or any extension device.
NEVER
move the log splitter while the engine is running. Shut off the engine even if you are leaving the log splitter for a
short period of time.
ALWAYS
avoid contact with the muffler and other hot areas of the engine during operation or after running to prevent
burns.
REPAIR AND MAINTENANCE SAFETY
NEVER
operate your log splitter when it is in poor mechanical condition or in need of repair.
Periodically check that all nuts, bolts, screws, hydraulic fittings and hose clamps are tight.
NEVER
alter your log splitter in any manner. Such alterations may cause your log splitter to be unsafe and will void the
warranty.
Perform all recommended maintenance procedures before using your log splitter.
Replace all damaged or worn parts immediately.
NEVER
tamper with the engine to run it at excessive speeds. The maximum engine speed is preset by the manufacturer
and is within safety limits. See engine manual.
ALWAYS
remove the spark plug wire before performing any service or repair on your log splitter.
ALWAYS
check the level of hydraulic oil and engine oil before operation.
ALL
replacement parts must meet manufacturer’s specifications.
Page 4
