![Speech Technology Center Gnome-Nano II Operation Manual Download Page 16](http://html.mh-extra.com/html/speech-technology-center/gnome-nano-ii/gnome-nano-ii_operation-manual_1345113016.webp)
Gnome-Nano II
16
7.3.3
Volume-Triggered Recording (VOX)
To enable the volume-triggered recording mode (VOX), do the following:
•
Enable this mode while configuring recording parameters and set recording volume thresholds (see
Section 9.4.5);
•
Move the recording slide switch located on the device case (
3
in Figure 1) to the
REC
position or
the remote control switch to the
ON
position.
•
Recording session will begin once the input signal level exceeds the specified start/stop threshold.
Recording stops once the volume level drops below the threshold and remains low over a specified
time.
•
To stop a volume-triggered recording, move the slide switch to the
STOP
position or move remote
control switch to the
OFF
position. The volume-triggered recording mode can be used in
combination with the scheduled recording mode (see Section 7.3.4).
7.3.4
Scheduled Recording Mode
Use scheduled recording mode when the exact start and stop time of a recording session is known
beforehand. It is useful for recording conferences, meetings, etc. This mode is especially handy if the
recording situation does not allow you to operate the device manually.
This mode allows you to start a recording session automatically at any desired time using built-in timers. To
enable the scheduled recording mode, while configuring the device parameters (see Section 9.4.10), do the
following:
•
Activate one or several timers;
•
Set the desired start and stop time for each recording session.
If multiple timers are enabled and the end of one recording session overlaps the beginning of
the next recording session, the device will record both sessions into one audio file.
In this case, manual recording controls usually have higher priority over the timer settings. If the button is not
locked, you can stop a scheduled recording by moving the switch button (
3
in Figure 1) first to the
REC
, and
then into the
STOP
position.
If the switch is disabled, you cannot stop the scheduled recording manually. Thus, the scheduled recording
will be stopped according to the timer, after the memory gets full or if the battery gets fully discharged. This
option is especially helpful while recording crucial information or important data as it ensures the
STOP
switch will not be accidentally moved.
Scheduled recording mode can be used in combination with the volume-triggered recording mode (see
Section 7.3.3).
When both scheduled and volume-triggered recording modes are on, recording session starts as
soon as the volume level exceeds the specified threshold within the time frame set in the timer
settings.