Spectrum DataScout 3920, Product Manual

Page: 14 / 24

14
INSTALLATION
After completing the pre - deployment steps (pages 9 - 11), the
DataScout is ready for installation.
Tools recommended for installation
•
7/16 - inch (11 - mm) wrench
• Phillips screwdriver
1. Attach the antenna to the DataScout.
2. Mount the DataScout to the tripod or another pole/surface
using the provided bracket and u - bolts/screws. See figures 3
and 4.
3. Connect the DataScout to the AUX port of your Weather Sta-
tion or Retriever using the appropriate cable (Black - Retriever,
Gray - Weather Station). Screw the strain - relief gland into the
threaded hole on the bottom of the housing.
4. Attach the snap connector to the rechargeable battery.
5. Mount the solar panel using provided hardware (see fig. 5 ).
Ensure that the panel is unobstructed and facing the equator.
Note that even partial shade will drastically reduce the effec-
tiveness of the solar panel.
6. Connect the solar panel to the DataScout using the included
barrel adapter. The black wire is ground ( - ). If using a non -
solar WiFi DataScout, connect the AC/DC adapter and plug
into a wall outlet.
7. Ensure the attached station/Retriever is powered on.
8. Wait 1 minute after powering the DataScout modem to check
signal strength and confirm acceptable communication. Press
and hold the DataScout button until the light comes on
(approximately 2 seconds) to initiate the test. If, after several
attempts, communication is still unsuccessful (red LED), try
moving the DataScout to an area with better signal coverage