Spectrum 1734, User Manual

Page: 25 / 78

User’s Manual Pub. 0300272-03 Rev. B
Chapter 3
Configuring the Module with
RSLogix™ 5000
This chapter covers software configuration of the module. More detailed
information about ControlLogix I/O Modules in general, and additional
information about features described below can be found in the
ControlLogix
Digital I/O Modules User Manual Publication 1756-UM058F-EN-P–May 2015,
and in the RSLogix 5000 Online Help.
The add-on profile may be downloaded at www.spectrumcontrols.com.
The generic point IO module profile can be used to represent the OE2CIH
module within RSLogix 5000. The generic profile should be used for RSLogix
5000 versions 14 and older. Before the generic profile can be added to the IO
configuration, the proper communication module needs to be added to the IO
configuration first. Follow the procedure below to add a communication module
to RSLogix 5000.
1. Add the new local communication module to your project.
2. Configure the local module, including:
a. Naming the module.
b. Choosing a Communication Format.
c. Setting the Revision level.
d. Setting the module location as necessary such as the slot number
for a 1756-L61 module.
e. Choosing an Electronic Keying method.
3. Add the new remote module to your project, such as a 1734 Control Net
adapter or Ethernet Adapter (that is, 1734-ACNR or 1734-AENT,
respectively).
4. Configure the remote module similarly to the local module.
5. Download the configuration to the controller.
Section 3.1
Configuring the Module
with RSLogix 5000
Once you have correctly installed your module, configure it as follows.
1. If needed, install a current copy of the correct AOP software. (If this is
not available, you will install a generic module instead.)
2. Start up your RSLogix 5000 software.