Spectrum 1734, User Manual

Page: 18 / 78

2-4 Chapter 2: Installation and Wiring
User’s Manual Pub. 0300272-03 Rev. B
electrical noise. Electrical noise coupled to the analog outputs will reduce the
performance (accuracy) of the module. Group your modules to minimize adverse
effects from radiated electrical noise and heat. Consider the following conditions
when selecting a location for the analog module. Position the module:
•
Away from sources of electrical noise such as hard-contact switches,
relays, and AC motor drives
•
Away from modules which generate significant radiated heat. Refer to
the module’s heat dissipation specification.
In addition, route shielded, twisted-pair analog input wiring away from any high-
voltage I/O wiring.
Section 2.4
Mounting
2.4.1 Before You Begin
Note that this product can be used with the following:
•
1734 ControlNet and EtherNet/IP adapters ONLY using RSLogix 5000
software version 11 or later
Refer to the following figures to familiarize yourself with major parts of the
module, noting that the wiring base assembly is one of the following:
•
1734-TB or 1734-TBS POINT I/O two-piece terminal base, which
includes the 1734-RTB removable terminal block and 1734-MB
mounting base.
•
1734-TOP or 1734-TOPS POINT I/O one-piece terminal base.
Figure 2-1. Hardware Overview