Assembly / Setup
0115348R3 Page 3 of 9
Changing rack rail position
1. Rack rails can be moved to an inner position to accommodate larger
knobs and plugs on rack-mount equipment. To move the rack rails
from the outer to inner position, remove the 1/4-20 x 5/8” PHM
screws attaching the rack rail brackets as shown in
Figure 2
.
2. Move the rack rails and brackets into the new position and reattach
with the screws.
Note: The rack rails are factory-installed
in the Masters in the outer position.
Phillips
Screwdriver
Tools
Required
Figure 2
inner rack rail
position
outer rack rail
position
Worksurface device installation -
(lecterns with worksurface cutout only)
1. To install a worksurface device, the included cover plate will need to be removed from the worksurface.
2. From under the worksurface, remove the wing nuts and cover plate strap.
Figure 1
.
3. Lift off the cover plate, then refer to the device instructions for the remaining installation and setup.
Figure 1
cover plate strap
wing nut
cover plate
worksurface
underside
