Maintenance
0110657R5 Page 9 of 11
After approximately 300 cycles of opening and closing, the friction dampener on the
worksurface lid should be retightened to 13 in-lbs using a torque wrench with a 4mm
hex driver. If a torque wrench is unavailable, tighten the friction damper with a 4mm
hex wrench 1/8 turn at a time and test. The correct adjustment is when the lid slows
down between 2-4” from closure.
Figure 7
.
Operation
lift bracket
monitor
compartment lid
For computer use:
Open the monitor compartment lid. Raise the monitor by pulling up
on the lift bracket until fully extended. Take out the keyboard and
mouse and set on the worksurface.
Figure 6A
.
Figure 6A
monitor
compartment lid
For classroom (worksurface) use:
Place the keyboard and mouse in the compartment tray under the
monitor. Lower the monitor by pushing down on the lift bracket until
the column is fully retracted, then close the monitor compartment lid.
Figure 6B
.
Note:
Lockable desks can be locked at this point for security.
Figure 6B
4mm hex wrench
friction
dampener
Figure 7
4mm hex wrench
(included)
Tools
Required
